Quarry School

Turning points — quick review

In plain words

The big picture. Use a graph’s changes of direction to put a lower bound on its degree.

Rule

A turning point is a point where the graph changes from rising to falling (a peak) or from falling to rising (a valley), read left to right.
A polynomial of degree n, where n is 1 or more, has at most n − 1 turning points.
Backward: a polynomial that is not constant and whose graph has t turning points has degree at least t + 1.

Step

  1. Use the turning-point definition on the graph described in the example. Read left to right: falling changes to rising at (−2, −13), rising changes to falling at (0, 3), and falling changes to rising at (2, −13). Count these direction changes, not the ends or a flat spot that keeps rising.

  2. Count t = 3 turns. Apply the bound t ≤ n − 1: 3 ≤ n − 1 gives n ≥ 4 after adding 1 to both sides. This is a lower bound, because a degree can allow more turns than a graph actually has.

  3. Use the end-behavior rule from the earlier lesson. Both ends point up, so the degree is even and the leading coefficient is positive. The smallest even degree allowed by the turn count is 4.

  4. Check that degree 4 can fit the stated shape with the example’s formula f(x) = x4 − 8x2 + 3. Its degree is 4 and its leading coefficient 1 is positive, so it allows at most 3 turns and both arms point up. Multiplying out (x2 − 4)2 − 13 gives x4 − 8x2 + 16 − 13 = x4 − 8x2 + 3, so f(x) = (x2 − 4)2 − 13. A square is never negative and is 0 only where x2 − 4 = 0, at x = −2 and x = 2, so the lowest outputs are −13 there. Between them, x2 − 4 runs from 0 down to −4 at x = 0 and back to 0, so its square climbs from 0 to 16 and falls back: the graph rises to (0, 3) and falls again. Outside −2 and 2 the square only grows, so both arms rise.

  5. Finish the check by substitution: f(−2) = 16 − 32 + 3 = −13, f(0) = 3 and f(2) = 16 − 32 + 3 = −13. This degree-4 polynomial has the three stated turns and both arms up, so degree 4 is possible as well as being the lower bound.

Strategy

  1. Trace the graph left to right with a finger or a pencil tip.

  2. Mark every peak (rising, then falling) and every valley (falling, then rising).

  3. Count the marks. Call the count t.

  4. Add 1 to t for a lower bound. Check the whole graph before naming the least degree: curvature or a level crossing can rule out a line.

  5. Use the end behavior to check the degree parity. If the question gives only turns and end directions, report the least degree those clues allow.

  6. Read the right arm: up means a positive leading coefficient, down means a negative one.

Question

A polynomial f has this graph, read left to right: it comes down from the upper left to a valley at (−2, −13), climbs to a peak at (0, 3), drops to a valley at (2, −13), and then climbs to the upper right forever. The table lists seven points on the graph. How many turning points does the graph have? What is the least possible degree of f? Is the leading coefficient positive or negative?

Answer

Turning points: 3, at (−2, −13), (0, 3) and (2, −13).
Least possible degree: 4 (the degree is even and at least 4).
Leading coefficient: positive.

Trap

Reading 'at most' as 'exactly'. A degree 3 polynomial does not have to have 2 turning points: y = x3 has none. A graph with 3 turning points does not have to come from degree 4: it could come from degree 6. Going from a formula of degree 1 or more, say 'at most n − 1 turning points'. Going from a graph that is not a flat line, say 'degree at least t + 1'.

Term

polynomial

Definition

A function built by adding or subtracting pieces, each a number times x to a whole-number power. Simplified without changing where it is defined, it has no x in the bottom of a fraction, under a root, or up in an exponent.

Term

term

Definition

One piece of a polynomial, cut off from the others at each plus or minus sign. The sign in front stays with its piece.

Term

coefficient

Definition

The number multiplying the x part of a term, sign included. In −5x2 the coefficient is −5. When no number is written, it is 1, so x3 has coefficient 1.

Term

degree

Definition

The highest power of x in a polynomial once it is multiplied out and like terms are combined, counting only terms whose coefficient is not 0. The zero polynomial has no degree. It is not the number of terms, nor the biggest coefficient. A plain number counts as power 0.

Term

leading term

Definition

The term with the highest power of x, sign and coefficient included. It need not be written first. When x is far from 0, it outweighs all the other terms.

Term

leading coefficient

Definition

The coefficient of the leading term, its sign included. Together with the degree, it decides where the graph's two ends point. In 3 + 2x − 7x⁴ it is −7.

Term

end behavior

Definition

What a graph does far to the left and far to the right. For a polynomial of degree 1 or more, each arm heads up forever or down forever.

Term

turning point

Definition

A spot where the graph, read left to right, switches between rising and falling: a hilltop or a valley floor. A polynomial of degree n, n at least 1, has at most n − 1.