Increasing and decreasing: where sine and cosine rise and fall — quick review
Think of climbing a staircase.
On a chosen interval, increasing means > gives f() > f(); decreasing means > gives f() < f(). On [0, 2π], sin increases on [0, ] and [ , 2π], and decreases on [ , ]. cos decreases on [0, π] and increases on [π, 2π].
1. Read what to compare: a larger angle is the larger input, but its sine or cosine may be a larger or smaller output.
2. Locate both angles. For a comparison by increasing or decreasing, both must lie in one interval where the requested function keeps the same direction of change.
3. Use the quadrant motion table, or combine neighboring quarters with the same direction: cosine decreases through I and II and increases through III and IV.
4. Increasing means the larger input gives the larger output. Decreasing means the larger input gives the smaller output.
5. If both angles are shifted by the same complete turn, their order is preserved. If you reduce them by different numbers of turns, compare the reduced inputs again before using the table. Their original order need not be the reduced order.
6. If the two values have opposite signs, the positive value is larger. If neither one interval nor signs decide the comparison, these rules alone are insufficient; use an additional taught exact-value fact.
7. Check the moving point: higher means larger sine; farther right means larger cosine. For negative outputs, a value closer to 0 is larger, such as − > −.
Read a reference-table entry in the column under its input or category in the matching picture.
Without a calculator, decide which is larger: (a) cos 20° or cos 70°; (b) sin 200° or sin 250°. The question compares two outputs; it does not require finding their decimal values.
(a) cos 20° is larger.
(b) sin 200° is larger.
Decreasing does not mean negative. In II, sine decreases while staying positive. In IV, sine increases while staying negative. Also, reducing two angles by different numbers of turns can change their order, so compare their reduced inputs before using a direction rule.
1. Locate both terminal sides and note the requested function.
2. Check whether both inputs lie in one interval with a single direction of change.
3. If so, compare the input order and apply increasing or decreasing.
4. If reducing large inputs, use one common shift where possible. After different shifts, compare the reduced inputs anew.
5. If the interval method does not apply, see whether opposite output signs decide the comparison.
The input t
On U, t is an angle in radians and the directed distance traveled from (1, 0). The notes reserve x for the point's first coordinate. Unsigned traveled length is |t|.
Quadrant
One of the four regions the two axes cut the plane into, numbered I, II, III, IV counterclockwise from the upper right. An angle is in the quadrant that holds its terminal side.
Coterminal angles
Angles that end on the same terminal side. They differ by whole turns: a multiple of 360°, or of 2π.
Increasing function
A function is increasing on an interval if a larger input always gives a larger output there: > means f() > f().
Exact value
A value stated without rounding, often written using whole numbers, fractions or square roots. An exact expression keeps the complete value instead of stopping at a rounded decimal.
Sine
Sine reads the unit-circle point's height.
Cosine
Cosine reads the unit-circle point's horizontal position.