Quadrantal angles: where tan, cot, sec and csc break — quick review
Picture the rider stopping exactly above, below, right of, or left of the wheel's center.
tan t and sec t: t ≠ + nπ, or t ≠ 90° + n·180°. cot t and csc t: t ≠ nπ, or t ≠ n·180°. An integer is a number such as −2, −1, 0, 1 or 2; n may be any integer. The notes write the same exclusions as ± nπ and ±nπ. Every other real input is allowed.
1. If the angle is negative or at least a full turn, add or subtract full turns (2π or 360°) to bring it between 0 and 2π.
2. Check whether it is a quarter-turn mark: 0 gives (1, 0), (90°) gives (0, 1), π (180°) gives (−1, 0), (270°) gives (0, −1). If it is none of these, all six functions are defined.
3. On the y-axis (x = 0): tan and sec are undefined, while cot and csc have values.
4. On the x-axis (y = 0): cot and csc are undefined, while tan and sec have values. In a table, write 'undefined' or 'n/a', as the notes do.
Read a reference-table entry in the column under its input or category in the matching picture.
The question asks which division formulas have a zero denominator at each angle. Which of tan t, cot t, sec t and csc t are undefined at (a) t = 3π and (b) t = −90°?
(a) cot 3π and csc 3π are undefined.
(b) tan(−90°) and sec(−90°) are undefined.
Calling a 0 on top 'undefined'. = 0 is an ordinary value. Only a 0 on the bottom breaks a function, so tan π = 0 is defined while cot π is undefined.
1. Reduce the angle by full turns to the interval [0, 2π), or [0°, 360°).
2. Find its terminal point if it is an axis angle.
3. Write the requested function as a fraction of x and y.
4. If the denominator is 0, report undefined. Otherwise divide.
Domain
All the inputs a function accepts. For the trig functions, the inputs are angles, or real numbers t read as radians.
Integer n
An integer is a whole number, including negatives and zero. In t ≠ + nπ, n ranges over every integer, so the rule excludes infinitely many inputs.
Quadrant
One of the four regions the two axes cut the plane into, numbered I, II, III, IV counterclockwise from the upper right. An angle is in the quadrant that holds its terminal side.
Quadrantal angle
An angle whose terminal side lies on an axis: a multiple of (90°), such as 0, ±, ±π, ±, 2π. It belongs to no quadrant.
Undefined
A function is undefined at an input when its formula would divide by zero there. No output exists, so that input is left out of the domain.
Coterminal reduction
Replacing an angle by its coterminal angle in [0°, 360°) or [0, 2π) before finding its quadrant or its value. The notes write 'co-terminal'.
Sine
Sine reads the unit-circle point's height.
Cosine
Cosine reads the unit-circle point's horizontal position.
Tangent
Tangent divides height by horizontal position.
Cotangent
Cotangent divides horizontal position by height.
Secant
Secant is the reciprocal of the horizontal coordinate.
Cosecant
Cosecant is the reciprocal of the height coordinate.