Amplitude measures height, not direction
Quick review (2 minutes)
Imagine a swing moving the same distance to either side of its resting place.
Rule: amplitude = |A| = . It is the distance from the midline to an extreme, not the full height. Negative A reflects the wave vertically.
Read A, the entire outside multiplier, including its sign.
Use |A| for the amplitude.
If heights are given instead, subtract minimum from maximum and divide by 2.
Keep A's sign when drawing which part of the cycle rises or falls.
From an equation, use the absolute value of A.
From a graph or data, measure the whole height and halve it.
Check that your answer is nonnegative.
Find A and the amplitude of y = −9 sin(x) + 2. The midline is y = 2, and one cycle runs from x = 0 to x = 4, with lowest point (1, −7) and highest point (3, 11). Confirm the amplitude from those two heights, then say whether the graph falls or rises first as it leaves (0, 2). The figure shows the midline with the five key points (0, 2), (1, −7), (2, 2), (3, 11) and (4, 2).
A = −9, and the amplitude is |−9| = 9 (not −9, and not 18). The heights agree: = = 9, so the full height 18 is twice the amplitude. Because A is negative, the graph falls first, from (0, 2) to its lowest point (1, −7), and rises to its highest point (3, 11) afterwards.
Do not report maximum-minus-minimum as the amplitude. It contains two amplitude distances.
Sine
The vertical coordinate of a point on a circle of radius 1 after turning through the input angle. Its abbreviation is sin.
Cosine
The horizontal coordinate of a point on a circle of radius 1 after turning through the input angle. Its abbreviation is cos.
Cycle
One complete run through a repeating pattern, from one position in the pattern to the next identical position with the same direction of motion.
Amplitude
The vertical distance from a wave's middle line to a highest or lowest point. It equals |A| and is always positive for a changing wave.
A
The signed multiplier outside sine or cosine. Its absolute value gives the amplitude; a negative A turns the basic wave upside down.
Absolute value
A number's distance from 0 on the number line. Distance keeps size and removes direction, so absolute value is never negative.
Maximum
The greatest output a wave reaches. For y = A sin(ωx − φ) + B, it is B + |A|.
Minimum
The least output a wave reaches. For y = A sin(ωx − φ) + B, it is B − |A|.
Peak
A highest point on a wave. Its vertical coordinate is the maximum output, while its horizontal coordinate tells where that height occurs.
Trough
A lowest point on a wave. Its vertical coordinate is the minimum output, while its horizontal coordinate tells where that height occurs.
Midline
The horizontal line halfway between a wave's greatest and least heights. Its equation is y = B, where B is the average of those heights.
B
The number added outside sine or cosine. It is the middle height and gives the midline equation y = B.
Range
All the output heights a function actually reaches. A sinusoidal wave's range includes every height from B − |A| through B + |A|.
Key points
Useful points that anchor a wave sketch. Across one cycle, choose the start and four more points spaced one quarter period apart.
Horizontal line
A straight line that stays at one height while extending left and right. Its equation has the form y = a fixed number.
Data
Recorded observations or measurements. A model uses these observations to estimate a pattern and predict other values.
Reflection
A flip across a line that preserves distances. Compared with the same positive multiplier and center, a negative outside multiplier exchanges heights above and below the midline.
1 In plain words
Imagine a swing moving the same distance to either side of its resting place. The distance from the resting place to one farthest position tells you how large the motion is. For a wave, that distance is the Amplitude. You measure from the middle to the top, or from the middle to the bottom. You do not measure all the way from bottom to top. The number A stretches or shrinks every height before anything is added outside. A negative A also turns the wave upside down. That flip changes which part comes first, but a distance cannot become negative.
Explain it like I am five
Picture a child on a swing that travels 2 meters forward and 2 meters back from its resting spot. That 2 meters is the swing's amplitude: the distance from the middle to one far end. The full 4 meters from end to end is twice the amplitude.
Take y = −6 sin x. The number multiplying the whole wave, A, is −6. Plain sine runs from −1 to 1, so multiply: when sin x = 1, y = −6 × 1 = −6, and when sin x = −1, y = −6 × (−1) = 6. The wave reaches 6 and −6, so the amplitude is |−6| = 6. The bars mean absolute value: a number's size without its sign.
Check with the heights: amplitude = = = = 6. The minus sign in A shrank nothing. It flipped the wave upside down, so it heads down first instead of up. A distance cannot be negative, which is why amplitude uses |A|.
2 Picture it
Reminder
Reminder: Absolute value, Signed multiplication, Subtracting negatives
- Absolute value. |−3| = 3 because −3 is 3 units from 0.
- Signed multiplication.
- Subtracting negatives.
3 Why
The basic sine and cosine outputs reach 1 and −1. Multiplying by A puts the two extreme outputs at A and −A before a vertical addition. Those positions are each |A| from 0. Their separation is 2|A|, so half the maximum-minus-minimum is |A|. Adding the same B to both heights leaves their difference unchanged. A negative multiplier swaps the extremes, which is why we keep the sign of A separate from the amplitude.
4 The rule
amplitude .
It is the distance from the midline to an extreme, not the full height. Negative A reflects the wave vertically.
The same idea, five ways
Amplitude is the distance from the middle of the wave to a peak.
The amplitude equals the absolute value of the outside multiplier.
- Amplitude = |A|
- |A| =
- Graph words: half the height from trough to peak.
Measure from a swing's rest position to one farthest reach.
The same idea, other ways
The amplitude marker covers only half the full bottom to top span.
Doubling a picture doubles its heights. Flipping the enlarged page does not change its size. Positive 3 and negative 3 both give amplitude 3.
Part 1: Positive A
Positive A changes the distance without reversing the heights.
- Rule: A = 2 gives amplitude 2.
The same idea, five ways
Positive A
Positive A changes the distance without reversing the heights.
- Rule: A = 2 gives amplitude 2.
Enlarge a photo to double the distance from its center to its edges.
Counterexamples
What it is not, and the tempting wrong moves.
Tips and tricks
- Say what the formula changes before calculating.
Part 2: Negative A
A negative multiplier changes distance and reverses which original heights point upward. This flip is a Reflection.
- Rule: A = −3 gives amplitude 3, with a vertical reflection.
The same idea, five ways
Negative A
A negative multiplier changes distance and reverses which original heights point upward.
- Rule: A = −3 gives amplitude 3, with a vertical reflection.
Turn the enlarged photo upside down; its size stays the same.
Counterexamples
What it is not, and the tempting wrong moves.
Tips and tricks
- Say what the formula changes before calculating.
Part 3: Amplitude from maximum and minimum
Measure the total span, then take half because the center splits it into equal distances.
- Rule: amplitude = .
The same idea, five ways
Amplitude from maximum and minimum
Measure the total span, then take half because the center splits it into equal distances.
- Rule: amplitude = .
Measure the distance from the bottom of a wheel to its top, then halve it.
Worked example
Recover amplitude from two heights
A wave has maximum 10 and minimum 2. Find its amplitude. You want the distance from the middle to either end.
Show the steps and the answer
- Total height .Subtract the lower height from the upper height to measure the entire span.
- Amplitude .The wave has equal height on both sides of its middle.
- The middle is ; and .A midpoint check independently confirms the distance.
Counterexamples
What it is not, and the tempting wrong moves.
Tips and tricks
- Say what the formula changes before calculating.
5 How
- Read A, the entire outside multiplier, including its sign.
- Use |A| for the amplitude.
- If heights are given instead, subtract minimum from maximum and divide by 2.
- Keep A's sign when drawing which part of the cycle rises or falls.
Find amplitude
- From an equation, use the absolute value of A.
- From a graph or data, measure the whole height and halve it.
- Check that your answer is nonnegative.
6 Worked example
Worked example
Amplitude when the outside multiplier is negative
Find A and the amplitude of y = −9 sin(x) + 2. The midline is y = 2, and one cycle runs from x = 0 to x = 4, with lowest point (1, −7) and highest point (3, 11). Confirm the amplitude from those two heights, then say whether the graph falls or rises first as it leaves (0, 2). The figure shows the midline with the five key points (0, 2), (1, −7), (2, 2), (3, 11) and (4, 2).
Show the steps and the answer
- Read the outside multiplier of : .A is the entire number multiplying the sine, sign included. The inside the sine and the + 2 added at the end are not part of it.
- Take the absolute value: amplitude .Amplitude is a distance from the midline to an extreme, and a distance cannot be negative, so the sign is dropped when measuring the size of the wave.
- Confirm with the heights. The highest point (3, 11) gives and the lowest point gives , so amplitude .Subtracting the minimum from the maximum gives the full height, 18, which is two amplitudes: one below the midline and one above. Dividing by 2 leaves one amplitude, and it matches |A|.
- Measure from the midline : up to the top is , and down to the bottom is .The amplitude runs from the midline to an extreme, not from bottom to top, so each of these distances must be 9. The full height 18 is not the amplitude.
- Bring the sign back for the shape. At , so the graph leaves (0, 2) going down to , comes back to (2, 2), climbs to (3, 11) and returns to (4, 2).With A = 9 the graph would rise first, to (1, 11). The negative A reflects the wave vertically across the midline, so the fall comes first and the rise second. Only the direction changes; the size stays 9.
Work to write
- amplitude = |A| = |−9| = 9
- = = = 9
- 11 − 2 = 9 and 2 − (−7) = 9
- A is negative, so the graph falls first from (0, 2) to (1, −7), then rises to (3, 11)
Counterexamples
What it is not, and the tempting wrong moves.
Tips and tricks
- Memory device: distance drops the sign.
- If the total height is 8, the amplitude is 4.
7 The trap
Do not report maximum-minus-minimum as the amplitude. It contains two amplitude distances.
Keep in mind
- Amplitude is half the top-to-bottom distance: a wave from 2 to 8 has amplitude = 3, not 6.
- Amplitude is never negative: y = −6 sin x has amplitude 6, and its minus sign only flips the wave.
- Adding a number outside moves the wave up or down but keeps its amplitude: y = 2 sin x + 7 still has amplitude 2, swinging from 5 to 9.
- Only the number multiplying the whole wave sets the amplitude: y = sin(8x) has amplitude 1, since the 8 sits inside.
Memory hook
Amplitude is a swing's reach: middle to one end, never end to end. Take half of top minus bottom, and let the absolute value bars drop the minus sign.
Flash cards
Say the answer out loud, then flip.